To Install the AutoBell school programmer:

‍

Step 1 Remove existing bell switch and mount the AutoBell module over the recess

Step 2 Bring the bell pair through the back of the mobile base and connect to the strip connector (2 red wires) ---- Contacts are normally open mode

Step 3 Power supply can come through the rear also if possible (adjacent lighting circuit OK, but should have an isolating switch)

‍

Alternative – fit a flex and plug extension from side or underside of the enclosure.

The Omron programmer is pre-programmed.

‍

Any queries, please call Ian on 027 495 4033

‍